Byan G104 900 Hydraulic 120VAC Swing Gate Operator Arm - Primary/ Slave Compatible
Call for price
ACCESSORIES & RELATED MODELS
Please Note: Order the G2M Control Panel for new installations along with hydraulic arm(s).
The 800/900 Series comes in three different styles and 2 different voltages. Hydraulic locks in both the open and closed positions. For gates greater than 12 feet in length, electric locks are recommended. In some states and cities (in case of a power outage), the gate must be able to be pushed open by the fire ore emergency vehicle. We can take out the hydraulic check valve in the closed position. You must then use an electric lock to keep the gate closed. With the operator mounted inside the property, the operator can be installed to swing inward or outward. Most mechanical operators must be mounted on the side the gate will swing toward.
Please call for assistance with the 220Volt not listed. Thank you. 775-588-1475 x 152
800/900 Standard Operator. This operator can be used for most applications. The gate leaf cannot exceed 16 feet. It will open a gate with a 90 degree swing in 12 seconds and close the gate in 14 seconds.
800/900 Slow Speed. This slow-speed operator should be used in applications where the gate is over 16 feet, the gate travels up or down a hill, and/or the gate frame will flex when it reaches the end of travel. It will open a gate with a 90 degree swing in 17 seconds and close the gate in 20 seconds.
800/900 Long. This operator is normally used in applications where the gate column is too large in diameter for normal mounting dimensions or in applications where an insert cannot be mounted in the column. It will open a gate with a 90 degree swing in 12 seconds and close the gate in 14 seconds.
The 800 is a 220 VAC Single Phase.
The 900 is a 115 VAC Single Phase.
Electric Motor | Single Phase Built-in Thermal Overload |
800A Series Power Supply | 220 VAC, 60 Hz. |
900A Series Power Supply | 115 VAC, 60 Hz. |
Capacitor Rating | 10 UF (800A) 35 UF/40 UF (900A) |
Standard Working Pressure | 1,650 PSI |
Maximum Working Pressure | 1,750 PSI |
Pump | Spur Gear .66 LTR/Min. |
Motor | 1/6 Horsepower |
Amperage Draw | 4 Amps |
Operator Length (with piston retracted and rear bracket and swivel joint installed) | 754 to 904 mm (29-11/16 to 35-5/8 inches) |
Operator Length (with piston extended and rear bracket and swivel joint installed) | 1,004 to 1,304 mm (39-1/2 to 51-5/16 inches) |
Operator Width | 3-3/8 x 3-3/8 inches |
Operator Height | 4-5/16 inches (w/lock cover) |
Speed to 90 Degrees | 13 Seconds |
Piston Stroke | 250 mm (9-7/8 inches) 400 mm (15-3/4 inches) |
Ambient Operator Temperature Range | -60 to 220 Degrees F |
Hydraulic Fluid | Tellus T-15 |
Adjustable Pressure Setting in Both Open and Closed Directions | |
Shipping Weight (Normal/Slow Speed) | 32 lbs. |
Shipping Weight (Long) | 27 lbs. |