Sales of Miller Edge, gate edge products, gate sensors, and sensing edges.

MillerEdge gate sensors and sensing edges.
MillerEdge, Inc. is the leading manufacturer of gate edge products, gate sensors and sensing edges. The most positive emergency stopping devices available for motor-driven doors and gates. It is our policy to supply quality products that conform exactly to all established requirements and the reasonable expectations of its customers. We are further committed to a company-wide program for continuous quality improvement.

Pick any DataSheet below for pricing & Specifications.

For installation on barrier gate arms weight grille and shutter applications with minimal over-travel. Use on or near gates for pinch point protection.		For installation on barrier gate arms, attach the rigid PVC mounting channel and slide sensor into the channel.

The ME123 is designed for use on 1-1/2 to 2 inch thick barrier gate arms. To install; slide the edge into the mounting channel and then mount the assembly to the door.		The MGO20 is designed for use on barrier gate arms gates up to 1-1/2 inches thick. To install, simply attach the rigid PVC or aluminum mounting channel and slide sensor into the channel. This edge cannot be bent or folded.

The Miller Edge Model MWT02 gate and door edge transmitter is designed to provide obstacle sensing protection for a variety of motorized gates and doors.		The Miller Edge Model MWTA02 gate and door edge transmitter is designed to provide obstacle sensing protection for a variety of motorized gates and doors. The Model MWTA02 is available with an Audible Alarm feature that activates when the battery has only 25% of its life remaining, indicating the battery should be replaced.

Both the Miller Edge receiver and transmitters are designed to have several selectable options not found on other radio controls. Simply select these options with the convenient dip switches and wire harness. The receiver will operate on either 12 or 24 volt AC or DC and is capable of sending a pulse or continuous signal.		Both the Miller Edge receiver and transmitters are designed to have several selectable options not found on other radio controls. Simply select these options with the convenient dip switches and wire harness. The receiver will operate on either 12 or 24 volt AC or DC and is capable of sending a pulse or continuous signal.