MillerEdge Sliding gate edge products, gate sensors and sensing edges.
MillerEdge, Inc. is the leading manufacturer of gate edge products, gate sensors and sensing edges. The most positive emergency stopping devices available for motor-driven doors and gates. It is our policy to supply quality products that conform exactly to all established requirements and the reasonable expectations of its customers. We are further committed to a company-wide program for continuous quality improvement.

Pick any DataSheet below for pricing  and Specifications.

The ME120 is designed for use on doors and gates up to 1-1/2 inches thick. To install, simply attach the rigid PVC or aluminum mounting channel and slide sensor into the channel.		The ME123 is designed for use on 1-1/2 to 2 inch thick doors and gates. To install, slide the edge into the mounting channel and then mount the assembly to the door.
The MGO20 is designed for use on doors and gates up to 1-1/2 inches thick. To install, simply attach the rigid PVC or aluminum mounting channel and slide sensor into the channel. This edge cannot be bent or folded.		The MGR20 is designed for use on 2 inch round gates. To install, simply attach with screws through mounting tabs and into gate. This edge cannot be bent or folded.
The MGS20 is designed for use on 2 inch square gates. To install, simply attach with screws through mounting tabs and into gate. This edge cannot be bent or folded.		The Miller Edge Model MWT02 gate and door edge transmitter is designed to provide obstacle sensing protection for a variety of motorized gates and doors.
The Miller Edge Model MWTA02 gate and door edge transmitter is designed to provide obstacle sensing protection for a variety of motorized gates and doors. The Model MWTA02 is available with an Audible Alarm feature that activates when the battery has only 25% of its life remaining, indicating the battery should be replaced.		Both the Miller Edge receiver and transmitters are designed to have several selectable options not found on other radio controls. Simply select these options with the convenient dip switches and wire harness. The receiver will operate on either 12 or 24 volt AC or DC and is capable of sending a pulse or continuous signal.
Both the Miller Edge receiver and transmitters are designed to have several selectable options not found on other radio controls. Simply select these options with the convenient dip switches and wire harness. The receiver will operate on either 12 or 24 volt AC or DC and is capable of sending a pulse or continuous signal.		The Miller Edge Model MWCK02 gate and door edge transmitter and receiver kit, is designed to provide a fully reliable, self checking communication between the 4-wire SensingEdge and the door or gate motor operator. When the SensingEdge detects an obstruction, a fault condition is communicated to the transmitter and the receiver. The signal is then passed on to the motor operator to control the motion of the door or gate