Please Note: Order the G2M Control Panel for new installations along with hydraulic arm(s). The 500 Series is a residential swing gate operator. As a light-duty operator, it should be subject to no more than 60 cycles per hour. This operator is recommended for gates 12 feet long or shorter that weight less than 1,500 lbs. Opening speed is approximately 12 seconds. It slows down the last 5 to 10 degrees of the swing.
Hydraulic locks in both the open and closed positions. For gates 12 feet in length, electric locks are recommended. In some states and cities (in case of a power outage), the gate must be able to be pushed open by the fire ore emergency vehicle. We can take out the hydraulic check valve in the closed position. You must then use an electric lock to keep the gate closed.With the operator mounted inside the property, the operator can be installed to swing inward or outward. Most mechanical operators must be mounted on the side the gate will swing toward.
Model 500
115 VAC Single Phase Built-in Thermal Overload
Model 500B
220 VAC Single Phase Built-in Thermal Overload
Capacitor Rating
35 UF/40 UF/10 UF
Standard Working Pressure
1,650 PSI
Maximum Working Pressure
1,750 PSI
Pump
Spur Gear .50 LTR/Min.
Motor
1/6 Horsepower
Amperage Draw
4 Amps
Operator Length (with piston retracted and rear bracket and swivel joint installed)
27.72 inches
Operator Length (with piston extended and rear bracket and swivel joint installed)
35.59 inches
Operator Width
3.39 inches
Operator Height
4.33 inches (w/lock cover)
Speed to 90 Degrees
12 Seconds
Piston Stroke
200 mm (7.87 inches)
Ambient Operator Temperature Range
-60 to 220 Degrees F
Hydraulic Fluid
Tellus T-15
Adjustable Pressure Setting in Both Open and Closed Directions