This is FAAC Loop Detector DSP 7. Hard wires into control panel backplate. Strictly for 620,615,640 FAAC Barrier Operators. This loop detector can handle all parking, drive-thru and access control applications. Can be used as a safety loop or as a free exit loop detector.
10-30 VAC/VDC
FEATURES:
Enclosure: Impact resistant, high temperature plastic
1.75" x 2.375" x 3.61"
Loop Size: Works with any in-ground inductive loop 20 - 1000nH
Frequency: Automatically tunes to 4 frequencies
Outputs: 2 separate relays that are front panel programmable
Delay: Yes
Details
Repalces FAAC 2667 and 2665 Loop Detectors
11 Pin Plug in base. Automatic calibration when switching or setting, a USB interface for use with modern diagnostic and service.
The same features as the those it replaces.
..
SPECIFICATIONS:
Dimensions: 4" x .87" x 2.75"
2 Relays
Relay A: Provides main detection output, modifiable by delay and extension
Relay B: Switch Selectable to 4 options - True presence, Pulse on Exit, Pulse on Enter, Loop fail output
Frequency: Automatically tunes to 4 operating frequencies
Sensitivity: 10 settings to ensure detection of high bed vehicles
Connector: 10 position terminal block (no harness required)
Indicators: Separate power/fail and detect LED..
This is FAAC Loop Detector DSP 7. Hard wires into control panel backplate. Strictly for 620,615,640 FAAC Barrier Operators. This loop detector can handle all parking, drive-thru and access control applications. Can be used as a safety loop or as a free exit loop detector.
10-30 VAC/VDC
FEATURES:
Enclosure: Impact resistant, high temperature plastic
1.75" x 2.375" x 3.61"
Loop Size: Works with any in-ground inductive loop 20 - 1000nH
Frequency: Automatically tunes t..
Application: 1/4" wide saw cuts, gated facilities
The Model PLB Preformed Loop is a prefabricated loop/lead-in assembly designed to be installed in 1/4“ wide saw cuts. The design allows for variations in the perimeter of the loop slot. There is no need for 45 degree corner cuts. The PLB loop cable, lead-in cable, and splice enclosure are designed for maximum reliability and long life. Wire insulation and cable jackets are Cross-linked Polyethylene (XLPE). XLPE insulation provides e..
Application: Highways - Install under Asphalt Overlay or Embed in Concrete
The Model PLH Preformed Loop is a prefabricated loop / lead-in assembly designed to be overlaid with hot asphalt or embedded in concrete.
Each component of the PLH (loop cable, lead-in cable, and splice enclosure) is designed to maximize durability, minimize water penetration, and maintain a flexible form that is easy to install and handle. The low profile loop cable and lead-in cable are 0.360&rdqu..