Reno AVI-BP Receiver Vehicle ID Detector

Reno AVI-BP Receiver Vehicle ID Detector

Reno AVI-BP Receiver Vehicle ID Detector

Application: Automatic Vehicle Identification Receiver, Shelf Mount, Single Code (Presence, Pulse, Sensitivity)

Identifies vehicles equipped with a uniquely coded AVI transmitter and provides two relay outputs; presence and pulse. The presence relay will activate as long as the AVI transmitters is in range. The pulse relay provides a single 1/4 second pulse when a valid code is received. 

The two LEDs on the front panel indicates  the presence of power (green LED) and a valid-coded transmitter within the loop area (red LED).  The receiver is connected to a loop installed in the pavement.  The AVI transmitter must be in close proximity to, or over, the loop for the receiver to respond.

The AVI-BP has a front panel sensitivity potentiometer. When turned clockwise the sensitivity increases. Turning the potentiometer counterclockwise decreases the sensitivity. The receiver is factory programmed to identify a single specific transmitter code and does not require any adjustments or setup.  The receiver is fully operational immediately upon application of power.


Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: